Raider Mascot Vinyl Transfer (Black)
Size: Approximately ??"(W) x ??"(W) (inches)
100% CLEAR CRYSTAL RHINESTONE
We guarantee Highest Quality Material in all of our Vinyl designs. Print on T-shirts, Tank Tops, Hoodies, Tote bags, Hats, Caps and Fabric etc.
(Temperature and Time Setting)
Rhinestone: Set Heat Press temperature to 330 degrees and timer to 10-12 seconds.
Rhinestud: Set Heat Press temperature to 330 degrees and timer to 6-8 seconds.
(HOUSEHOLD IRON INSTRUCTION)
(It is always recommended to use a Heat Press machine for Rhinestone transfer to any fabric) Preheat iron to cotton setting 340 degrees. Carefully lift and separate the rhinestone clear sheet from the white sheet (stones should stick to the clear plastic sheet). If any stones have shifted out of place, carefully put them back into place using tweezers or any other tools. Place the transfer sheet, stone side down onto the fabric and press gently with your hand. If it is not in the desired position, lift and reposition. (DO NOT PULL the SHEET ON THE FABRIC AS STONES MAY SHIFT) Place the Hot Iron on it and apply steady pressure for 15 seconds (DO NOT MOVE IRON AROUND AS STONES MAY SHIFT). Place iron over other design area for another 15 seconds and repeat till entire design is pressed. Slowly peel the clear plastic sheet away from the fabric. If stones are not sticking, replace the plastic sheet back onto the shirt and re-iron again.
HEAT PRESS MACHINE INSTRUCTION
Set Heat Press temperature to 330 degrees and timer to 12 seconds. Place the fabric on Heat Press bed. Take Rhinestone transfer sheet and carefully lift and separate the rhinestone clear sheet from the white sheet (stones should stick to the clear plastic sheet). If any stones have shifted out of place, carefully put them back into place using tweezers or any other tools.Place a Teflon paper over the Rhinestone design area. Heat Press for 12 seconds. Slowly peel the clear plastic sheet away from the fabric. If stones are not sticking, replace the plastic sheet back onto the shirt and Heat Press again for 4-6 seconds.
Wash the garment inside out in cold delicate cycle and hanger dry.
PLEASE NOTE: We pack our rhinestone transfer designs very tightly to ensure your item arrives intact. However sometimes few stones may shift during shipping or in transit. It might require you to place the stones back into the place before ironing or heat press. You can place your fingure over the sheet and push the stones to move it back to the right place. Some larger transfers will be shipped in two pieces. This is to ensure your transfer arrives intact. The two pieces will be easy to line up and iron on.
Your one stop shopping for all Rhinestone transfer design, Iron on Transfer Hot Fix Motif, Bling stones, DIY for T-shirts, Hoodies, Tank Tops, sweatshirts, caps, Tote bags, etc.
THANK YOU VERY MUCH FOR SHOPPING WITH US.
PLEASE VISIT US AGAIN FOR NEW DESIGNS ADDING EVERYDAY IN OUR STORE.
$$$$$$$$$ :) :-) HAPPY BUYING :) :-) $$$$$$$$$
Vinyl transfer for Mugs. ORACLE 651 vinyl has 13.5” printing area (width is 13.”) GHAPHTEC cutter setup: Move the left roller towards right in the middle roller holder area. Move the right roller a little right so that the Graphtec cutting area is more than 13.5” Make the design in Mug measurement for ORACLE 651 vinyl for Mug size Set the cutting area to (13.5” cutting area) RAIDERS vinyl transfer for Mugs 3.5x3.5 Faith Over Fear Mug transfer 2.7(H) x 3.5(W)